厌氧滤池处理纺织印染废水的中试研究

对厌氧滤池反应器处理难降解印染废水进行中试研究。结果表明,厌氧滤池反应器水力停留时间(HRT)在8.1～14.6 h之间,进水COD浓度波动较大(500～1 000 mg/L)时,对COD平均去除率为20%。印染废水的BOD5/COD由0.23提高到0.35,废水可生化性明显改善。印染废水中硫酸根浓度略有下降,去除浓度为70 mg/L左右。厌氧滤池进出水颜色明显变化,由紫红色变为蓝黑色,紫外可见光谱分析表明废水中的有机物结构发生变化。     

稻草制浆黑液生物＋混凝处理试验

通过对稻草制浆黑液厌氧、好氧、混凝处理组合工艺的试验研究，探索该工艺的可行性，考察了不同温度、不同有机负荷下，该类废水的生物处理效果以及后续混凝效果。结果表明：中温35℃是厌氧阶段最佳处理温度，好氧阶段不同负荷条件下，CODCr去除率基本相同；经厌氧－好氧处理，黑液CODCr和木质素去除率分别为80％和30％，色度去除不明显；混凝阶段CODCr和木质素去除率分别为70％和90％，色度去除率达90％以上，出水达到国家标准。     

Effect of nitrite on hydrolysis-acidification, biogas production and microbial community in semi-continuous two-phase anaerobic digestion of sewage sludge

Previous study found that the pre-treatment of sewage sludge with nitrite improves the biogas production during the mono/two-phase anaerobic digestion (AD) using batch biochemical methane potential tests. In this study, the effects of nitrite on hydrolysis-acidification, biogas production, volatile solids destruction and microbial composition in semi-continuous two-phase AD of sewage sludge were investigated. The addition of nitrite promotes sludge organic matter solubilization (+484%) and VFAs production (+98.9%), and causes an increase in the VS degradation rate during the AD process (+8.7%). The comparison of biogas production from the acidogenic and methanogenic reactors with or without the addition of nitrite implies that the nitrite has no significant effect on the overall biogas production of two-phase sludge AD process. High-throughput sequencing analysis shows that the microbial communities of bacteria and archaea in two-phase AD reactors significantly changes after the addition of nitrite. Vulcanibacillus (bacteria) and Candidatus Methanofastidiosum (archaea) become the dominant genera in the acidogenic and methanogenic reactors with the nitrite respectively. These findings provide new insights about using nitrite to promote the organic matter degradation of sewage sludge in a semi-continuous two-phase AD system.     

Fe^0-厌氧微生物体系处理活性艳红X-3B的试验研究

采用间歇式摇床试验，研究了葡萄糖共基质条件下Fe^0-厌氧微生物体系中Fe^0投加量、pH值、染料初始浓度对活性艳红X-3B模拟废水脱色率的影响，比较了Fe^0-厌氧微生物、纯厌氧微生物及纯Fe^0 3种体系中废水的脱色效果。结果表明：Fe^0-厌氧微生物体系中初始浓度（50～500mg／L）对活性艳红X-3B的脱色率影响不大；而Fe^0投加量、pH值存在一个最佳范围；当Fe^0投加量为260mg／L，pH值为6．0，污泥浓度为0．35gVSS／L，停留时间约为30h时，体系中活性艳红X-3B的脱色率可达90％左右，比相同试验条件下纯Fe^0、纯厌氧微生物体系达到此脱色率所需时间分别缩短了约1／2、7／10。在Fe^0-厌氧微生物体系中，由紫外可见分光光度分析可推测活性艳红X-3B的脱色机理主要是其偶氮键发生断裂，生成苯胺和萘类物质，而且苯胺和萘类物质能得到进一步降解。     

NaCl和KCl对厌氧污泥抑制的动力学研究

在厌氧颗粒污泥和厌氧絮状污泥系统中,进行盐质量浓度(NaCl或KCl质量浓度,下同)对厌氧污泥抑制动力学的研究,得到不同拟合的COD降解动力学方程及参数.实验结果表明:当盐质量浓度为10～30 g/L时,KCl对厌氧污泥的COD比降解速率的抑制程度大于NaCl;当盐质量浓度由0 g/L增至10 g/L时,半速率常数逐渐增加;当盐质量浓度由10 g/L增至30 g/L时,半速率常数逐渐减小;在厌氧污泥系统中,NaCl抑制作用下的盐抑制常数高于KCl,且颗粒污泥的盐抑制常数高于絮状污泥.     

UASB反应器处理染料及印染废水的研究进展

综述了国内外UASB反应器处理染料及印染废水的研究概况.分析了UASB反应器处理废水存在的问题,并给出了相应的建议.展望了UASB反应器处理染料及印染废水的发展趋势,指出厌氧UASB-好氧法组合工艺是目前处理染料及印染废水的一种经济而有效的方法.     

餐厨垃圾厌氧消化中硬脂酸钙的形成及作用

在稳定运行的餐厨垃圾单相厌氧消化体系中，出现白色颗粒状物质，且随着负荷的提高，其数量和粒径不断增加。利用能谱技术分析白色颗粒的元素组成，结合傅里叶红外光谱和13C核磁共振技术分析白色颗粒中的官能基团。经过研究分析认为，该白色颗粒的主要成分为长链羧酸钙盐，具体为硬脂酸钙。同时，对其形成过程进行了分析。该物质的形成对餐厨垃圾中油脂的去除提供了新的思路和途径。     

Performances of mesophilic anaerobic digestion systems treating poultry mortalities

Abstract

A closed‐loop anaerobic digestion system consisting of a leachbed (LB) and an upflow anaerobic sludge blanket (UASB) was tested as an alternative for the disposal of poultry mortalities. This paper compares the performances of three LB‐UASB treatment systems with different initial moisture contents in the LBs. Each LB was loaded with one chicken and 5, 10 or 18 liters of water. The LBs initially carried out the hydrolysis/acidification phase while the UASBs the methanogenesis phase. Due to repeated inoculation by the UASBs, the LBs with 10 and 18 liters of water started producing methane on day 5, while the one with 5 liters of water on day 19. However, methane production rates were low before day 40 for the LB with 10 liters of water and day 60 for the other LBs. Methane production gradually improved as the LBs continued to receive ungranulated sludge from the UASBs. The LBs eventually became balanced methane reactors. Continued balanced fermentation in the LBs resulted in leachates with very low substrate concentrations that could no longer support high‐rate methanogenesis in the UASBs. Consequently, methane production rates from the UASBs decreased quickly while that from the LBs reached peak levels. Cumulative methane production from each LB eventually exceeded that from its connecting UASB. After 118 days of digestion, 414, 437 and 470 liters of methane were produced from the three systems, respectively. Cumulative methane production from the LBs with 5 and 18 liters of water accounted for 63% of the total methane produced from their respective systems. The LB with 10 liters of water produced 75% of the total methane from that system. Methane yields ranged from 0.485 to 0.554 m³ (Kg TS) ¹. About 86% of the initial dry weight was biodegraded. All three systems performed very well with little operational problems. Overall, the system that started with 10 liters of water in the LB performed the best. Strategy for enhancing system performances and implementing farm applications are discussed.     

丁酸胁迫对产氢污泥以厨余为底物的产氢影响

采用丁酸对产氢污泥进行胁迫处理,经胁迫后的污泥接种厨余垃圾进行产氢实验,考察丁酸胁迫对提高产氢性能的影响。结果表明,低浓度胁迫能提高产氢污泥的耐丁酸性,从而提高产氢量,而胁迫浓度过高则抑制产氢污泥活性,胁迫浓度呈"horm esis"效应。实验采用的4 g/L胁迫浓度为最佳,反应结束后,丁酸浓度和产氢量分别为8 417.1 mg/L和63.72 mL/g VS,比空白提高了31.3%和114%。产氢过程中SCOD的主要来源是有机酸。对产氢污泥胞外多聚物(EPS)的测定表明,厨余垃圾酸化速率、氢气产生速率和EPS总量成正相关。     

厌氧发酵系统中回流沼液的产甲烷活性研究

为确定两阶段厌氧发酵系统合理的污泥回流时段,对厌氧发酵系统排出沼液产甲烷活性进行了研究。通过对这些沼液在后储罐放置的不同天数(0~5 d)测定其不同的活性,用间歇实验方法测定最大比产甲烷活性(Um ax.CH4)作为厌氧污泥的产甲烷活性指标。结果表明,排出的沼液产甲烷活性在不同的时间段有所不同,经实验得出沼液放置第2 d时的产甲烷活性最高,从而确定该两阶段厌氧发酵系统排出污泥合理的回流时段应该是沼液进入后储罐的第2 d。进而为在线活性污泥与后储罐最佳活性时段污泥混合的污泥回流工艺提供理论依据。